Good ventilation is required in confined areas to ensure proper drying. The temperature of the substrate should be minimum -5☌ and at least 3☌ above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate. Please contact your local Jotun office for more information. The coating may be used on other substrates. Coated surfacesĬlean, dry and undamaged compatible primer. Roughness: using abrasives suitable to achieve grade Fine to Medium G (30-85 µm, Ry5) (ISO 8503-2) Shopprimed steelĬlean, dry and undamaged approved shopprimer. Bare steelĬleanliness: Blast cleaning to Sa 2½ (ISO 8501-1:2007). The surface should be assessed and treated in accordance with ISO 8504. Surface preparationĪll surfaces should be clean, dry and free from contamination. Hong Kong rules: Category of paints - Other vessel coatings VOC 260 gms/ltr HK EPD method (Ready to use) Exempt compound - N/A Specific gravity: 1.51 kg/ltr (A+B) Both VOC and Specific gravity values provided are typical values, and will vary according to colour chosen. If exact match to colour standards and long term cosmetic performance is needed please see our range of topcoats and finishes. Note that primers used as the final coat may fade and chalk in time when exposed to sunlight and weathering effects. Appendix 3 Gloss Flat Gloss retention Fair Water resistance Very good Abrasion resistance Very good Solvent resistance Excellent Chemical resistance Excellent Flexibility Good Film thickness and spreading rate Minimum Maximum Typical Film thickness, dry (µm) 75 250 125 Film thickness, wet (µm) 100 340 170 Theoretical spreading rate (m²/l) 9,9 3 5,9 Physical properties Colour Grey, Red, Buff, Light Red, Grey XO Solids (vol %)* 74 ± 2 Flash point 32✬ ± 2 (Setaflash) VOC 230 gms/ltr UK-PG6/23(97).
Can be used alone or in various systems of primers and topcoats. Recommended useĪs an anti corrosive primer and/or intermediate coating for corrosion protection of steel and other substrates in athmospheric exposure where fast dry-to-recoat and/or dry-to-handle times are desired. Penguard Express is a fast drying, high solids two-pack epoxy coating which may be applied in high film thickness and at lower temperatures.
0 kommentar(er)
